MIL-C-8605B
(a) Qualification inspection: The qualification inspection consists of the examinations
and tests accomplished on samples submitted for qualification (See 4.3).
(b) Quality conformance inspection: Quality conformance inspections are those
examinations and tests accomplished on caps manufactured and submitted for acceptance
under contract (See 4.4).
4.3 Qualification Inspection. Qualification inspections shall consist of qualification tests
on two caps by the supplier, and verification tests on two caps at a Government facility.
The qualification test are outlined in 4.3.1.3. The verification tests shall consist of any of
the tests of 4.6 which the Government desires to perform. Successful completion of this
inspection is required for qualification.
43.1 Test Samples. Test samples submitted for government verification shall be
identified with the manufacturer's own part number. Samples submitted shall `be
accompanied by a complete set of detail and assembly drawings and a complete test report
(4.3.1.1 and 4.3.1.2). Samples shall be submitted to the Naval Air Propulsion Center,
Trenton, NJ 08628.
4.3.1.1 Drawings. The contractor's drawings submitted with the verification test samples
shall conform to DoD-STD-100. The drawings shall show a cutaway section of all parts in
their normal assembled position and shall specify part numbers of all parts and
subassemblies. The following data shall be furnished on or together with the assembly
drawing:
(a)
Mounting dimensions
(b)
Over-all dimensions
(c)
Materials and construction, treatment and finish
(d)
Pressure rating
4.3.1.2 Manufacturer's Test Report. The test reports submitted with the qualification
test samples shall include the following:
(a)
Report of all test, graphically presented when possible, together with a detailed
statement indicating compliance or extent of noncompliance with all
requirements of this specification, referring specifically to paragraph numbers.
Summary of tests
(b)
(c)
Diagrams of all test setups
(d)
Outline and description of test and test conditions
Copies of test log sheets
(e)
Photographs when available
(f)
4.3.1.3 Qualification Tests. The qualification tests shall consist of all the tests listed in
Table I, conducted in the order listed on the specific qualification sample cap, following the
appropriate test method described in the reference paragraph number.
4.3.2 Rejection and Retest. When the cap fails to meet any of the requirements of the
qualification tests, the program will be halted until the extent and cause of failure are
determined. The action required to correct the fault will be reported to the qualifying
6
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business